For Administrators only.
1️⃣ Signals Synergy Configuration ➡ select
| |
| 2️⃣ Synergy Experiment Settings pane ➡ select Auto Numbering | |
| 3️⃣ Synergy Experiment Auto Numbering section ➡ select Enable global auto numbering for Synergy Experiments |
Supporting Knowledge
- When this option is enabled, the number within a Number Sequence Attribute, applied as the Name, will be consecutive across the whole system. Numbers will be independent of the Synergy Experiment's number. This setting must be saved before changes are applied.
- This setting must be saved before changes are applied.
- Auto Numbering is set to start at 1. It can be changed as long as the Starting Synergy Experiment ID value is higher than the Next in Sequence value.
Comments
0 comments
Article is closed for comments.