For Administrators only.
1️⃣ Signals Synergy Configuration ➡ select
| |
| 2️⃣ Material Types pane ➡ select Reference Tables ➡ select Design/Compound/Batch | |
| 3️⃣ Compounds – Reference Table section ➡ select Enable | |
4️⃣ Compounds – Reference Table section ➡ select
| |
| 5️⃣ Compounds – Reference Table section ➡ select |
Supporting Knowledge
Three types of Reference tables are available: Design, Compound, and Batch. All three can be enabled and edited in the same way, and the same configuration settings are provided for their properties.
Enabling will allow referencing of Design/Compound/Batch in Work Order Reference Tables.
Configure which properties can be shared to a CRO via Reference Tables in Work Orders. Shareable to CRO properties are available to include in Reference Tables of this material's designs. Sensitive properties require a privilege to include.
Note: The above steps can be applied to both the Compounds and Normalized Compounds Material types. The instructions are identical; however, the same subsection should be selected under Normalized Compounds in the Material Type side setting pane, rather than the Compounds subsection pictured above.
Comments
0 comments
Article is closed for comments.