Error while configuring RStudio to use TIBCO Spotfire Analyst's TERR engine.

Error while configuring RStudio to use TIBCO Spotfire Analyst's TERR engine.

You may come across below error when you configure RStudio to run either TIBCO Spotfire Analyst's TERR engine or TIBCO Enterprise Runtime for R engine itself. When you open RStudio after configuring this, you may face below error:
----------- 
Cannot connect to R
rsession.exe - Entry point not found
-----------

Cause:
This error occurs if you are not using compatible version of RStudio that was used in testing the particular TIBCO Enterprise Runtime for R (TERR) release you are running. It is important to work with the version of RStudio that was used in testing the particular TIBCO Enterprise Runtime for R (TERR) release you are running, because RStudio is a third-party product, and we have no control over changes made in its subsequent releases. 

The system requirements page for each TERR release shows the exact RStudio version that was used in TERR release testing. The following examples are from the system requirements pages for TIBCO Enterprise Runtime for R 5.0.0 :

https://docs.tibco.com/pub/enterprise-runtime-for-R/5.0.0/doc/html/TIB_terr_Documentation/GUID-144C89C4-D154-4614-A074-EDF110AEFE6C.html

RStudio IDE Compatibility:
RStudio Desktop : 1.1.463
RStudio Server   : 1.1.463

Note:
You can also check release notes of each TERR version to know tested version of RStudio with respective TERR version on https://docs.tibco.com/products/tibco-enterprise-runtime-for-r-5-0-0 https://docs.tibco.com/pub/enterprise-runtime-for-R/4.5.0/doc/html/TIB_terr_Documentation/GUID-144C89C4-D154-4614-A074-EDF110AEFE6C.html