Shop

Your Notifications (0)

There are currently no notifications. You're all set!

Demos Trials
Knowledge Base
ChemDraw and ChemOffice+ Products Signals Notebook E-Notebook and ChemBioOffice Enterprise Spotfire and Signals Spotfire Products Columbus Signals Image Artist
Downloads
Downloads
Community
Support Forums Ideas Portal Product Basics
About Support
Legal Resources Support and Maintenance Plans Product Life Cycle Support News
Contact Support

Changes in Spotfire version 10.3: How to execute commands from the command line in TIBCO Spotfire Server 10.3 and higher

Rich Talbot
  • Updated
Date Posted:
Product: TIBCO Spotfire®

Problem:

Changes in Spotfire version 10.3: How to execute commands from the command line in TIBCO Spotfire Server 10.3 and higher


Solution:

In TIBCO Spotfire Server 10.2 and previous versions, config.bat (config.sh on Linux) - used for executing server commands - was located in <server installation dir>/tomcat/bin.

From version 10.3, this location has changed. To execute commands from the command line, you need to make sure to:

  • navigate to the new location when opening a command prompt.
  • update all scripts (from earlier versions) containing execution of server commands to use the new path to config.bat (or config.sh)

  From TIBCO Spotfire Server 10.3, config.bat (config.sh on Linux) is located in <server installation dir>/tomcat/spotfire-bin Doc: Executing commands on the command line

Related articles