Prior to this task:
✔ Normalization method must be applied from the Extensible Normalization app.
|
1️⃣ Extensible Normalization – Analysis tab ➡ select |
|
|
2️⃣ Extensible Normalization – Visualization tab ➡ Visualization settings ➡ select |
|
|
3️⃣ Extensible Normalization – Visualization tab ➡ select |
|
|
4️⃣ Extensible Normalization – Configuration tab ➡ select |
|
|
5️⃣ Plate view after normalization visualization ➡ select |
|
|
6️⃣ Plate view after normalization visualization ➡ select well(s) to exclude |
|
|
7️⃣ Signals Groups panel ➡ Analysis exclusion – Manual excluded ➡ select |
|
|
8️⃣ Plate view after normalization visualization ➡ select |
|
|
9️⃣ Extensible Normalization – Analysis tab ➡ Normalization Settings ➡ select |
Supporting Knowledge
Note: In the data table where the normalization method was applied, the user can find the hc_User exclusion tag column, which displays the Manual excluded status of the selected wells.
Optionally, from the Signals Groups panel, under the Analysis exclusion – Manual excluded section, select the [three dot button], then select Reset to include all the excluded points.
Comments
0 comments
Article is closed for comments.